SmaRT Console Box Remote
©
2020 Cervis, Inc. 11
2.7
Dissociate Console Box from System Base Unit
During instances of severe interference
—or perhaps when troubleshooting—it may become
necessary to break the established communications link between the console box and the
system base unit. This is done via the following steps.
Note: The console box remote must be OFF, and the base unit must have power
disconnected before beginning dissociation.
Dissociate from the Base Unit
1. Stand near the base unit with the console box remote OFF and power removed
from the base unit (that is, either detach cables from the base unit, or disconnect
the power source).
2. Release the Stop switch on the remote.
3. Hold the Dissociate switch (S13) DOWN. While holding the Dissociate switch
DOWN, activate the console remote by holding the ON/OFF switch (S12) UP.
Continue to hold both switches.
4. When the TX LED blinks once per second, apply power to base unit.
5. All LEDs illuminate for
~
1 second. Release the Associate and ON/OFF switches
(S13 and S12) when they go out.
Only the console box
TX
LED is active and none of the base unit LEDs are active, indicating that
the communication link is broken.
Figure 5. Dissociate Console Box from Base Unit
Step 3
S14 S13 S12
