Operating Instructions
CertainTeed
TO LOAD NO-COAT® PRO CORNER INTO THE
NO-COAT® PRO MACHINE:
1. Push in perforated section above finger hole.
2. Tear out perforated large end panel and remove.
3. Using finger holes, remove perforated panels on
both sides of the box.
4. Lift box with perforated end panel facing machine, and
mount over spindle.
5. Box should fit snugly against spindle arm, resting on the spindle
and corner pin.
6. On opposite box side, make sure box sits on spindle and is secured
in place by spindle cap.
7. Pull end of NO-COAT PRO Corner out of box and slide under
guide pin.
8. Feed NO-COAT PRO Corner through open slot into feed rollers
using the feed knob. Make sure center groove in product lines
up with centering roller. Turn feed knob until product stops
against inside cutter blade.
9. To remove or adjust position of NO-COAT PRO Corner, push
down on feed release lever.
Spindle Arm
Spindle Arm
Corner Pin
Top View
Spindle
Spindle
Spindle Cap
DO NOT tear or
remove this area
of box!
Front
Back
Guide
Feed Rollers
Feed Knob
Feed
Release
Lever
Centering
Roller
Guide Pin
T
urn Feed Knob
counter-clockwise only!