Valeo
Assembly instructions
General Product information
This product is suitable for indoor dry locations only.
This product can be dimmed with most standard dimmers.
Assembling the body
1.
Place the two wood components of the body on an ele-
vated fl at surface such as a table. Remove the cord from the
rear of the verticle body then align the two wood compo-
nents of the body as pictured on the right, making sure to
align the holes for the fasteners.
2.
With the components aligned, insert the two 5” long
1/2-13 socket head cap screws into the holes and slowly
tighten both screws using a 3/8” hex key. Assure that the
joint closes evenly.
3.
Once the joint has closed evenly, tighten the screws.
4.
With the body components now securely fastened,
press the wire and cord stock into the groove covering the
joint.
CERNOGROUP.COM T_949.715.1534
1751 MCGAW AVE, IRVINE, CA 92614
COPYRIGHT 2015 CERNO LLC.
C
