Ceragon FibeAir IP-20F, Руководство по установке

Страница: 40 / 63

Installation Guide for FibeAir IP-20F
Page 40 of 63
Ceragon Proprietary and Confidential
7.1 Establishing a Connection
You can connect to the IP-20F unit using a TP cable with a LAN connection or using a
Serial RS-232 cable.
7.1.1 Connecting to the Unit with a Serial Connection
1 Connect an RS-232 cable with an RJ-45 interface from your laptop or PC to the
Terminal Interface on the IP-20F front panel.
Figure 10: Terminal Interface
2 Configure the following settings for the COM port you are using on your PC or
laptop:
o
Bits per Second – 115,200
o
Data Bits – 8
o
Parity – None
o
Stop Bits – 1
o
Flow Control - None
7.1.2 Connecting to the Unit with a LAN Connection
FibeAir IP-20F contains two FE management interfaces, which connect to a single RJ-45
physical connector on the front panel (MGMT). For details on which type of cable to
use to utilize either one or both management interfaces, refer to
Management
Interface Cable Options on page 13.
Connect the cable to Management interface (MGMT) on the IP-20F front panel, and to
the LAN port on the PC.
Figure 11: Management Interface