FibeAir® IP-10G
Installation Guide
Ceragon Proprietary and Confidential
Page 30 of 71
10.3
Configuring IP Addresses
You can configure the local IDU’s IP address in the Local IP Configuration
section of the Management page.
Note:
After the link is up and running, you can also configure the
remote IDU’s IP address, in the Remote IP Configuration
section of the Management page.
In protected configurations, the floating IP address feature provides a single IP
address that will always provide direct access to the currently active main
unit. This is used primarily for web-based management and telnet access.
The user can configure a floating IP address in the active unit, and this IP
address will be automatically copied to the standby unit.
To configure local IP settings:
1 Select
Configuration > General > Management
. The Management page
opens.
2 In the Local IP Configuration section of the Management page, enter the IP
address of the local unit, its subnet mask, and the default gateway.
3 Optionally, enter a floating IP address. The following limitations apply to a
floating IP address:
The floating IP address must be different from the system IP address.
The floating IP address must be in the same subnet as the system IP
address.
