Centroid OAK, Руководство по установке

Страница: 55 / 96

A
PPENDIX
A: T
ROUBLESHOOTING
Symptom Or Error Troubleshooting
E
RROR
I
NITIALIZING
MPU11
•
Firewall or antivirus problem, see Section 3.1.
•
Ethernet Cable is not shielded, see Section 2.3.
•
Lack of power to the Oak Board.
•
An incorrect IP configuration, see Section 3.2.9.
For further troubleshooting, refer to TB 279:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/279.pdf )
452 PC R
ECEIVE
D
ATA
E
RROR
Most often caused by noise.
•
Ensure the Ethernet cable is shielded, it will have metal clips on each end. See Section
2.3.
For further troubleshooting, refer to TB 270:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/270.pdf )
J
OG
P
ANEL
C
OMMUNICATION
I
N
F
AULT
•
If the optional Jog Panel/Pendant will not be installed, change the “Jog Panel
Required” to “No” in the control configuration screen.
Power off the system and restart.
•
If the optional Jog Panel/Pendant was ordered, confirm that it is plugged at both the
Oak Board and on backside the Jog Panel board itself on the header labeled CPU10.
For more information see TB 282:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/282.pdf )
A
XIS DOES NOT MOVE THE CORRECT
DISTANCE
The motor revs/inch, or mm's/rev, has not been set correctly.
Ensure you have properly calibrated your machine. Section 6.5.
For more information see TB 36:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/36.pdf )
A
XES DON
'
T MOVE
- N
O
E
RROR OR
F
AULT DISPLAYED
•
The feedrate override is turned down to zero. Confirm that the feedrate override is set
to ~100%.
•
E-Stop button is depressed. Release the E-Stop button, the “Emergency Stop
Released” message should appear.
•
The control is in incremental jog mode. If the LED is lit on the INCR/CONT key, the
control is set to incremental jog. Press the INCR/CONT key to toggle the LED off and
attempt to jog.
See TB 285 for more information:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/285.pdf )
Page 53 of 72 Axes don't move - No Error or Fault displayed
T:\_Docs working\Oak Board Manual\Oakboard install manual V2 4-10-15.odt