Central Pneumatic Contractor 97520, Руководство по установке и эксплуатации

Страница: 10 / 24

SKU 98464 For technical questions, please call 1-800-444-3353. Page 10
Release the trigger and squeeze it
again. The tool must cycle (fire)
once only . With the Trigger held,
carefully lift the nailer and press it
against the workpiece again. The
tool must not cycle (fire) . If it fails to
act in the manner explained in bold,
have it repaired by a qualified service
technician.
Loading the 97526 Air Pin Nailer
ALWAYS wear 1.
ANSI-approved impact safety gog-
gles when reloading or doing any
other maintenance on this tool.
Other people in the work area must
also wear ANSI-approved impact
safety goggles.
Make sure Nailer is not attached to
2.
the air hose whenever loading tool.
Depress upper tip of the Click Lever
3.
(59). The Side Cover (34) will pop
open.
Insert a row of fasteners (not includ-
4.
ed) into the Upper Magazine (47/51).
Make sure the pointed ends of the
fasteners are loaded with the points
downward. Also make sure fasteners
are not dirty or damaged
Slide the Side Cover (34) back over
5.
the Upper Magazine (47/51) and
press the upper tip of the Click Lever
(59) inward to lock Side Cover (34) in
place.
Loading the 97520 Air Brad Nailer
ALWAYS wear 1.
ANSI-approved impact safety gog-
gles when reloading or doing any
other maintenance on this tool.
Other people in the work area must
also wear ANSI-approved impact
safety goggles.
Make sure Nailer is not attached to
2.
the air hose whenever loading tool.
Slide the Pusher (63) back until it
3.
locks in place.
Place a full clip of the desired size
4.
Brads (3/4” to 2”) in the Magazine
Assembly (70). Up to 100 Brads may
be loaded in the Magazine.
While holding the Pusher (63) in 5.
place, press the Release (74) and
slide the Pusher forward.
Loading the 97524 Nailer/Stapler
ALWAYS wear 1.
ANSI-approved impact safety gog-
gles when reloading or doing any
other maintenance on this tool.
Other people in the work area must
also wear ANSI-approved impact
safety goggles.
Make sure Nailer is not attached to
2.
the air supply whenever loading tool.
Depress the Latch (73) and pull back
3.
on the Tail Cover (78), opening Mag-
azine A (67A).