INSTALLATION GUIDE
A
C-0442
15 ELEMENT
YAGI ANTENNA NEXT G
NOTE: cable must be kept clear of the reflector.
NOTE: Drain Hole must be on this side.
NOTE: These connectors must be covered with a waterproofing substance.
1/ Taking note of the antenna drain hole - slide the antenna Ubolts over the vertical boom
and tighten the nuts.
2/ Attach the feed cable (not supplied) to the antenna and run it down to the equipment.
Secure the cable to the vertical boom with cable ties (not supplied).
3/ Fit mating connector to the feed cable and attach test equipment. Check for a suitable
signal level.
If the signal level is unsatisfactory - loosen the angle adjustment screw on the angle
bracket and adjust the ante nna angle for the best signal.
4/ Replace the angle adjustment screws and lock the antenna angle into place.
5/ Seal the connector union with a waterproofing compound.
Vertical Mounting Boom
Ubolts
Waterproofing on connectors
NOTE: Cable must be kept in
close to the boom and clear of
the antenna elements.
Angle
adjustment
screw
20.0°
Phone: (03) 5334 2513
Web:
www.
wiltronics
.com.au
A
C-0442
