UP
H
E
B/C
5
F
G
D
3
A
x2
STEP 4
Remove orifice plug and
install storage box
Firstly, install the storage box on the
axle, then press it down slightly.
First attach the thumb
screw (A) to the
threaded hole of the
plug and then pull it
together.
Control Panel
After connecting the product's power plug to an external power source, raise the product to the
appropriate height with the control panel. Then remove the four holes on the front panel by
hand-tightening the screws (A). Remove the storage box from the package and secure it to the
left and right sides of the product through the reserved hanging shaft as shown.
STEP 5
Install TV panel
Attention:
If you do not need to install the TV, please
ignore next steps.
Use a screwdriver to attach the screws (D), washers (G),(H) and the TV
panel to the threaded holes on the front panel of the product. Use the
magnetic level (F) to calibrate whether the TV panel is installed horizontally.
A magnetic level meter (F) can be used to calibrate the installation level of
the TV panel.
Screwdriver
STEP 6
Connect the TV to the TV plate
Suit for M8 Screw
Television
Suit for M6 Screw
Use a screwdriver to attach the screws (B) or screws (C), stuck metal sheet (E),
TV plate, washers (H) to the TV.
Stuck Metal Sheet(E)
Television
Connecting cables
STEP 7
Insert the power cord of the TV into the threading sleeve
Hanging the TV
STEP 8
Install the TV on the TV panel and tighten the screws with a screwdriver,
then plug the TV's power cord into the power strip inside the product.
Power outlet
(located on the inside
of the product)
Screw
Power line
Threading sleeve
Common fault treatment
The following tips will help you detected and eliminate the common fault and error.If the fault you met is not listed below, please contact with your
supplier. Only themanufacturer and professionals are capable for investigating and correcting those fault and error.
Fault phenomenon
Method
No response while long pressing
down arrow after connected with
a power supply
1.Check if all the cables be connected well
1.Check if all the cables be connected well
2.Contact your supplier or dealer
2.Contact your supplier or dealer
No response while pressing up
arrow/ down arrow after
connected with a power supply
Rising in a low speed
1
.
Check if overloaded, max loading: 125kg;
1
.
Check if overloaded, max loading: 125kg;
1
.
Check if overloaded, max loading: 125kg;
2
.
Contact your supplier or dealer
2
.
Contact your supplier or dealer
2
.
Contact your supplier or dealer
The motor not move as instructed
1. Contact your supplier or dealer
1.Reposition
2.Contact your supplier or dealer
Go down but not go up
Downward sliding
Frequently Reposition
Overwork
Duty cycle: Max 2min on/18min OFF
1
.
Restart after suspend for 18mins while
connecting with power;
2
.
Contact your supplier or dealer;
D
x4
G
x4
x4
H
x4
Magnetic
Level
Magnetic Level
D
4
G
H
B
x4
C
x4
E
x4
H
x4
