Page
1
of
7
Getting Started Guide for the RoboxPRO
Getting Started with the RoboxPRO
Thank you for purchasing a RoboxPRO FFF 3D Printer. This information will help you get started using your new
printer. Please follow the unboxing and setup guide to get your printer out of the box and set up for use.
Installing AutoMaker
AutoMaker is the software that allows you to load models, slices those models, and sends the resulting file to the
printer. The file is then stored on the printer so that the printer can be disconnected for the remainder of the print if
you so desire.
You will need to download AutoMaker from the following website:
www.cel-robox.com/downloads
Please select the appropriate version for your computer. Once the file is downloaded, you will need to install the
software by running the installation program. You can run the program just as any other program on your
computer.
Connecting RoboxPRO
The 3D printer will require two connections: one AC power connection and one network connection. Please note
that the power supply on the 3D printer is non-switching so please make sure the power supply is set to the proper
voltage value to avoid damaging the printer. 3D printers sold in Europe are preset to 230 VAC. Those sold in the USA
or shipped to the USA from a European provider are preset to 115 VAC and will need to be changed. The power
supply is on the bottom of the printer; a small switch inset in the side of the power supply will allow you to select
the proper voltage.
Plug the power cable into the socket on the back of the RoboxPRO next to the power switch. Plug the other end
into a high quality surge protector or battery backup unit. Please note that 3D printer damage caused by power
problems is not covered under warranty.
If you will use the RoboxPRO on a wired network, plug the CAT5e network cable into the network jack on the back
of the 3D printer. Plug the other end into your network outlet.
For WiFi operation, see the WiFi setup section.
Choose the print head you would like to use and install it. RoboxPRO comes with three print heads: the single
material QuickFill V2 print head (black), the DualMaterial print head (gray), and the SingleX with Olsson Ruby nozzle
print head (clear). Install the print head by inserting its tail into the opening in the X-Carriage and tightening the
retaining screw on the back of the X-Carriage until the screw can’t be turned, usually 4-5 full turns. Please
remember to turn off the printer before changing the print head. See the section on Print Heads to help choose the
print head appropriate for the project you are running.
Once the RoboxPRO is connected to power, and a print head is installed, you can turn the 3D printer on with the
switch on the back of the printer. Please note that this is also the emergency shutoff, which will immediately cancel
any operation in progress. The printer will not retain the current status of any running operation and will have to be
restarted.
The printer will take about 4-5 minutes to boot and be completely ready for operation.