Cegasa eBick MCP Series, Руководство пользователя

Страница: 9 / 42

www.cegasa.com
www.cegasa.com Page -7- User Manual R10 – First steps –
3.2 General information
The eBick is a smart energy storage system with Li-ion cells.
The whole system contains a high energy capacity. To minimize the risk of electric shock,
short-circuit, explosion and/or fire, follow the relevant procedures and local guidelines,
as well as the instructions that are included with the system.
Only qualified personnel should perform the installation, in accordance with the
applicable regulations. Systems with visible electrical connections have to be isolated
from public access. For safety reasons, cover all direct connections and terminals.
Carefully read, understand and apply all requirements presented in this section.
3.3 Safety instructions
– Potential hazards
•
The area around the eBick shall be kept clear and free of combustible
materials, gasoline and/or other flammable fumes, vapours and liquids.
•
The area defined by safety margins for the necessary supply and venting
of air shall be respected.
•
In the event of an emergency the eBick has electrical safety cut-off
elements (fuses and contactors). It is advisable to install an element that
protects against overcurrent and possible short-circuiting. It is also
advisable that the cut-off element can be manually operated if necessary.
Remember, because this is a battery the STRING’s internal DC bus will
always have a voltage.
•
Do not use the module if any of its parts have been immersed in water.
A water damaged cell is potentially dangerous. Any attempts to use the
system could cause a fire or an explosion. In such cases, contact CEGASA
ENERGIA to have the battery pack inspected.
•
The following instructions shall always be followed:
o
Any air inlet or outlet within the room shall be kept clear and
free of obstacles.
o
The floor shall be capable of bearing the weight of the STRING.
o
There shall be no obvious signs of wear on any STRING
element.
o
As this is a battery, there is voltage on the +/- terminals
whenever the MCP contactor is closed.