CEFLA NewTom 5G Series, Руководство по обслуживанию, Страница: 15 / 23

NewTom 5G series – Patient Table Service Procedures 3-7
3.1.4 Calibration sequence
WARNING:
In case of it is necessary to perform PANT. FC BOTH
calibration, if the patient table is mechanical connected with
the 5G series gantry, exit from TOOLS page, slide the
stretcher completely out of the gantry and completely draw
back the pantograph by using
BACK button.
In case of
table installation , console replacement or firmware update , perform the following
calibrations:
1) Insert the device serial number (following procedure SET SERIAL NUMBER )
2)
Set the console position (following procedure CONSOLLE RIGHT/ LEFT )
Consolle
right
Consolle
left
3)
Select the right type of mounted potentiometer (following procedure NEW TABLE POT. TYPE /
OLD TABLE POT. TYPE)
OLD TYPE potentiometer (cod. 97643400)
mounted on patient table with S/N: 0001 ÷ 0004 , 0006 ÷ 0011 (included )