Press “#”,Input “8002”,
then input Setup Code or
Admin Code(88888888 or
66666666 by default)
Press “4” to enter unlock
code item.
9. Change Unlock Code:
If door station runs as Debug State, you can press “1#” to activate Tools Menu, then select “2”
to enter setup page,then select 4 item.If it runs as Normal State, follow these steps:
[ 8002 ]
Please Input Password
1
2
3
6
5
4
7
8
9
#
0
*
RF CARD
1 . L a n g u a g e [ 1 ]
2 . To n e S e l e c t [ 0 3 ]
3 . To n e V o l u m e [ 0 3 ]
5 . D i s p l a y M o d e
6 . C l o c k
7 . S e t u p C o d e
8 . A b o u t
9 . D e f a u l t
Press No.
to select
*Back
Setup
*Back
[ - - - - ]
( * * * *)
# Save
4 . U n l o c k C o d e [ 1 1 1 1 ]
4 . U n l o c k C o d e [ 1 1 1 1 ]
Input 4 digits number,
then press “#” to update
10. User Card Management:
This section explains how to configure the key fob function on DMR18,The key fob is used to
open the lock. Total 1000 key fobs can be registered with one door station. When swiping the
fob to the door station, the distance must be less than 3 centimeter.
Key Fobs must be registered on the Door station that can be used to open the door.
Register the Key Fobs:
All the registered key fobs are called User Cards/User Key Fobs. New fobs/cards need to be
registered one by one to the Door station to become a valid User Card/User Key Fob; and
every User Card/User Key Fob is related to a certain Monitor Address (Flat code).
When the door station is standby, press [#] --> [9008] -->Password([66666666 by default]) to
get into the Debug Mode Menu, then Press [1 #] --> [3] Card Manage -->[1] Add Card to get
into the Add Card page. Please see the followings.
-16-