EN
EN
300-LADJ
Electromagnetic Lock Bracket
1
Instructions of Use
Quick Start Guide
The bracket comes completely assembled. Mount the bracket, fit the mag to the slider
plate, line up with the armature, wire up, power up, tighten up and walk away.
Note: Each 300-LADJ bracket is bespoke to each maglock type and size. Please ensure
you have the correct bracket for the relevant mag lock.
What
is
this
bracket
for?
• The 300-LADJ bracket is useful when the maglock cannot directly fit under the tran-
som and where you would normally use an “L” bracket.
• This bracket allows infinite adjustment and positioning of the maglock. It can then
meet the armature perfectly with minimal effort.
• Depending on the size of the magnet you can slide the plate forward or backward
and even angle it, if that is what is needed.
• There is a cavity and a cut out in the bracket to make cabling easier, without
exposing or pinching the cable.
• It allows you to adjust the position of the magnet easily even after mounting.
Bracket Fitting
The 300-LADJ is easy to fit:
1. Fit the main body to the transom and the armature to the door.
2. Secure the magnet to the sliding plate.
3. Slide the plate into the bracket and line it up to the armature plate.
4. Tighten the screws.
