CDR FOODLABFAT, Руководство оператора

Страница: 13 / 29

Operator’s manual
October 2012
13
3 Installation
3.1 Receipt of the instrument
Each apparatus is checked following specific procedures and instruments by cdR
before being shipped. However, damage could occur during transportation and will
not be the responsibility of cdR. Effectuate a visual control of the packaging and the
apparatus to check that there is no visual damage due to knocks and bangs. If
damage can be seen, send back the apparatus to the service department for a
functional check.
3.2 Positioning and electrical connections
DO NOT SMOKE while operating with reagents! Danger of fire!
For the installation of the FOODLABfat
instrument proceed as follows:
A . Take the FOODLABfat out of the carton and put it on a plane surface in such a
position that it is not exposed by mechanical vibrations or extreme temperature
fluctuations or excessive light.
B . Connect the external power adapter to the port at the rear of the instrument
(Figure 3.1) using the appropriate power cord to the mains (110V to 230V)
Figure 3.1 ports
C
. In case the adapter is different from the one included with the instrument, check
that the electrical and safety characteristics (12 Vdc - 1,4A) are equivalent (CE
mark) and that the polarity of the connectors is respected Figure 3.1).
D . If necessary, insert the paper roll into the printer module by opening the protective
cover and insert the roll as indicated in Figure 3.2 and 3.3.
Open in menu the printer dialogue and press any times
line feed to move the paper
through the unit.