
Installation and Troubleshooting Guide
All rights reserved. Reproduction or use of content, in any manner, without express written permission by CDI Electronics, Inc., is prohibited.
CDI Electronics
•
111 Commerce Circle
•
Madison, AL 35758
•
Fax 256-772-5701
•
www.cdielectronics.com
CDI P/N: 116-7323
This unit replaces P/N: 817323A3, A4
Warning! This product is designed for installation by a professional marine mechanic. CDI Electronics cannot be held
liable for injury or damage resulting from improper installation, abuse, neglect or misuse of this product.
Installation
1. Disconnect and remove the old switch box.
2. Check for DC voltage on the kill (stop) wires (usually Black/Yellow) with the key-switch in the on and off position. At no time
should you see over 2 volts DC on this wire as severe damage to the power pack can occur.
3. Loosely attach the mounting plate to the switch box (Potted side) using the supplied screws.
4. Route the Green coil wires through the hole in the mounting plate.
5. Connect the trigger wires according to the color of the wires.
6. Connect the Black/Yellow wire to the Black/Yellow kill wire from the engine harness.
7. Slide the mounting bracket through the hole in the mounting plate so that the mounting bracket will clamp the mounting plate
when tightened.
8. Position the switch box as shown below and install the remaining mounting screw.
9. Tighten the two mounting brackets screws.
10. Connect the green coil wires to the coils.
11. Connect the Purple/White, Blue and Black wires to the Converter box.
CONNECTION
LEGEND
Function
Color
Trigger Color
Coil #
1
Green
Brown
Coil #
2
Green/White
White
Coil #
3
Green/Red
Violet
Coil #
4
Green/Black
Black
Coil #
5
Green/Yellow
Yellow
Bias Circuit
White/Black
White/Black
Kill/Stop
Black/Yellow
Inverter Activation
Violet/White
High Voltage
Blue
Ground
Black
Mounting bracket shown