CDH AMT AIRMASTER, Руководство пользователя

Страница: 14 / 27

10 AMT 12_00
T
T
R
R
A
A
N
N
S
S
P
P
O
O
R
R
T
T
A
A
N
N
D
D
U
U
N
N
P
P
A
A
C
C
K
K
I
I
N
N
G
G
G
G
E
E
N
N
E
E
R
R
A
A
L
L
The units are separately packed in cardboard boxes, on one pallet tied with tape.
To prevent damage to the unit, it is recommended that the unit is transported to its final destination
IN its packing.
When the unit is stored temporarily, it must be stored in a dry place until transport to its final destination
T
T
R
R
A
A
N
N
S
S
P
P
O
O
R
R
T
T
Smaller units can usually be moved by manpower and/or using a trolley.
To move larger units, a forklift should be used.
The units are always supplied on a pallet: please leave this in place until the final destination.
To prevent damage, note the following:

When using a forklift, ensure that the forks are long enough to reach to the end of the pallet.

When using a forklift the unit should only be lifted with the pallet or reinforcement under the unit.

Pushing with the forklift is permitted only if a rigid plank or reinforcement is applied over the complete length of
the unit.
The units should always be transported the right way up. Although under some circumstances they have to be
transported flat, e.g. to clear a narrow passage, they should never be placed flat for transport in trucks or for long
term storage (> 12 hours).
If the units must be moved in another way, other precautions must be taken to prevent damage to the housing.
IGNORING THESE GUIDELINES CAN CAUSE DAMAGE
U
U
N
N
P
P
A
A
C
C
K
K
I
I
N
N
G
G
When cutting the packaging always avoid damage to the unit.
Plastic, cardboard and wood should be removed separately for later recycling.
ON RECEIPT OF THE UNIT ensure that no transport damage has occurred.
The carrier must be informed of any damage immediately in writing
ALWAYS DETERMINE WHERE THE UNIT IS TO BE INSTALLED.
ENSURE THAT THE UNIT WILL LATER BE EASILY ACCESSIBLE FOR MAINTENANCE
(SEE WORKING SPACE).
R
R
E
E
M
M
O
O
V
V
I
I
N
N
G
G
T
T
H
H
E
E
P
P
A
A
L
L
L
L
E
E
T
T
When the equipment has reached its final destination, it can be removed from the pallet.
No specific instructions can be given here, as this action depends on the size of the unit and the room.
T T R R A A N N S S P P O O R R T T S S C C R R E E W W S S
THE RED MARKED TRANSPORT SCREWS OF THE COMPRESSOR - NOT ON AMT40 -
HAVE TO BE REMOVED ON INSTALLATION.