CD Concept CD200, Руководство пользователя

Страница: 1 / 3

Rally Timing System CD200 – www.cdconcept.be
Marshal’s User Manual – Rally Timer (yellow)
Copyright ® - CD Concept sprl Help us to improve our products, send your comments to info@cdconcept.be
2004-06-02 Page 1 of 3
1. Settings
Before the competitors arrive, both the ‘ Mode’ and ‘ Position n° ’ have to be set.
Those parameters should be given by the rally organizer.
The mode appears when you press the ‘ESC’ button.
The position n° appears on the top right of the display.
1.1. Enter the Menu
To enter the setup menu, hold both 'ESC' and 'ENT' buttons for minimum 5 seconds. After
this delay, the first function in the menu will appear.
Four functions are available:
- F1: Mode, set the mode
- F3: time, set the time
- F2: P-n°, set the Position number - F4: ISP, In-System Programming mode.
Use:
- ‘STOP/SELECT’ button, to select the function.
- ‘RESET’ button to go back to F1.
- ‘ENT’ button to execute/enter the function.
- ‘ESC’ button to quit the menu.
1.2. F1: Set the Mode
Enter the setup menu, select 'Mode' function and press the 'ENT' button.
Use the 'STOP/SELECT' button to select the mode.
The following modes are available:
St00
Start Mode at xx:xx:00
St30
Start Mode at xx:xx:30
St0:30
Start Mode at xx:xx:00 or xx:xx:30
St0:20:40
Start mode at xx:xx:00, xx:xx:20 or, xx:xx:40
tC
Time Control
F
Flying Finish
Press 'ENT' to validate the change or 'ESC' to go back to the menu leaving the mode unchanged.
1.3. F2: Set the Position n°
Enter the setup menu, select 'P n°' function and press the 'ENT' button.
Use the 'STOP/SELECT' button to set the units.
Use the 'RESET' button to set the tens.
Press 'ENT' to validate the change or 'ESC' to go back to the menu leaving the P-number unchanged.
1.4. F3: Set the time Should not be used by the marshal.
1.5. F4: ISP Should not be used by the marshal.
2. Presenting the ibutton at position n°01
The communication with the ibutton is usually so fast that it looks instantaneous.
However at Position n° 01, the rally timer will clean all the ibutton memory from old data and the communication will
take a few tenths of a seconds. The best way to present the ibutton is to insert it in the reader and exert a slight lateral
pressure to make a good contact with the external ring and
STAY STILL (don’t move) until the transmission is
completed. The ‘HOLD’ message will appear until data transmission is completed.
3. Low battery warning on the Rally Timer
If the Low Battery warning appears (LO) on the top right of the display, the battery can be replaced without losing the
time if you insert the new battery within 15 seconds.