Manual CCV IM30
Rev.07
7 / 25
© CCV GmbH - Diese Unterlage darf ohne unsere Zustimmung nicht vervielfältigt oder weitergegeben werden.
This document must not be copied or distributed without our approval.
4.2
Back view
1
RS232-A (device, cash register)
2
RS232-B (host, external devices)
3
headphone jack (mic + speaker)
4
LAN port (10/100 Mbit)
5
digital I/O (power, 6pin WAGO connector)
6
executive/ MDB Master port
7
connector for external 4G antenna
8
SAM card module
9
USB type A port (host)
10
USB type C port (OTG)
11
download button
12
reset button
13
HDMI port
14
MDB Slave port
15
MDB status LED
4.3
Contactless card reader
The CCV IM30 has a contactless card reader with an
RF antenna located on its front face. The read area is
the upper half of the touchscreen. Use contactless card
from a distance of 0 to 4 cm. For best results, place the
card as close to the screen as possible and center it
within the area marked in the right figure.
4.4
Status LED and proximity detector
CCV IM30 has a RGB status indicator LED above the
proximity detector. The operation of the LED is soft-
ware controlled. It can display a light in red, green or
blue.
The CCV IM30 has an optical proximity detector lo-
cated near the lower right side of its front face. The
proximity sensor detects objects at close distance to
sensor (range of 0cm to 8cm). It is meant to perform
function such as providing a wakeup signal to the rest
of the device when a user is detected or calibrating
backlight intensity to fit the brightness of a given envi-
ronment.
