Technical instructions
MPZ
v1.1
www.ccei.fr
5
4. Installation
4.1. Integration in a fuse box
The smart controller for piezoelectric switch MPZ must be installed on a standard DIN rail (OMEGA
rail) in a fuse box. It cannot be used as it is.
The module has a system which enables it to be automatically clipped onto the rail;
1.
First clip on the top of the module
2.
Place a flat screwdriver into the clip on the bottom of the module to activate it
3.
Clip on the bottom of the module and remove the screwdriver
4.2. Electrical connection
Installing this product could expose you to an electric shock. We strongly rec-
ommend that you use a qualified professional. An installation error could put
you at risk and irreversibly damage the product and the equipment connected
to it.
For safety reasons and according to the standard NF C15-100, the case in which
the MPZ is installed must be set up
• either more than 3 m 50 from the edge of the pool. This distance is measured
taking into account any workaround of obstacles. If the case of the MPZ is
installed behind a wall, this is therefore the distance required to go round it
and re-connect to the case.
• or in an underground room in close proximity to the pool. In this case, the
room must be accessible by a trap door which requires the use of a tool to
be opened.
The smart controller for piezoelectric switch MPZ
• must not be directly installed outside or inside, it should be integrated in a fuse box which is
protected from the rain, any spraying from cleaning or watering, and UV rays (sun).
• must be placed in a fuse box which is, in turn, on a flat and stable support which is firmly attached
to the wall or its support.
The piezoelectric switch connection is established on the terminal block at the top of the module,
and the supply and the output points should be connected to the terminal block at the bottom of the
module, according to the diagram below;
