CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 220 / 359

CCI.TECU
– Operation
21
4.3.3.3 Tractor settings
This tab shows the tractor name and the settings for wheel speed sensor, ground
speed sensor, PTO sensor and 3-point hitch sensor.
You have the following operating options:
Edit name
Select signal source
Select between:

n/a

Signal connector (ISO 11786)

CAN 1 and

GPS (only for the ground speed sensor).
Activate power management
Enter the switch off delay value
Unlock X-Sensor
Note
With a terminal of hardware generation 1, you can either select wheel or ground
speed sensor as the signal source. The other sensor is automatically shown as
n/a . The selection is mutually exclusive.
With a terminal of hardware generation 2 or higher both speed signals can be used
simultaneously.
Note
If CCI.TECU is in passive mode (see chapter 4.4), it is not possible to edit the
parameters of the active tractor, that are sent from the other TECU. In this case,
the relevant buttons are greyed-out and "CAN 1" is indicated as the selection.