3
connect the left channel output of the CDT-17A to the left channel source input on
the amplifier, and then, connect the right channel output of the
to the right
channel source input on the amplifier.
A
(
)
-
.
,
.Digital Output
- .The CD -1 A's coaxial digital output jack supplies an unprocessed digital
signal. Using a standard 75 ohm coaxial digital cable, connect the
coaxial output to the coaxial digital input connector on the outboard D/A decoder.
- .Connect the analog output jacks of the D/A decoder to the source input jacks
of an amplifier.
. Connect the supplied power cord to the CD-1 A's power inlet and the AC power
outlet.
Before turning on the unit, be sure you have connected the unit to the other com-
nents correctly.
You can use both the two kinds of output connections or each one.
To prevent loud noises, make sure the CD player is turned off when you make
any signal connection.
CDT-17A
2.
nalog Outputs balance .
A pair of XLR jacks supplies an analog balance output signal from the CDT 17A
to the source inputs of an audio amplifier or other component Using the balance
cable connect the left channel balance output of the CDT-17A to the left channel
balance source input on the amplifier, and then, connect the right channel balance
output of the CDT-17A to the right channel balance source input on the amplifier.
3
3-1.AES/EBU Output
Using a 110 ohm balance cable connect the AES/EBU output jack of the
CDT-17A to the AES/EBU input jack of the D/A decoder.
3 2
T 7
CDT-17A's
3 3
4
7
po
IV PRECAUTIONS
Cautions for Safety
Follow these cautions to avoid malfunction or serious damage to the unit.
Disconnect the Power Cord from the AC outlet by pulling the plug, not the cord.
Keep the Power Cord away from heating appliances.
Keep the unit away from sources of liquid.
Do not remove the outer cover.
Do not use the unit if there is lightning. Unplug the Power Cord from the AC
outlet as soon as possible
Place the unit on an even and stable place where is well ventilated.
Do not place the unit in the following places:
In a room exposed to sunlight for a long period time.
Near a strong light source or a heater.
Where there is steam or soot.
Where there is dust or humidity or a strongly magnetized object.
Installation and Handling
