INSTALLATION
1) Before installation identify all components and inspect the product for any damage. Prior to installation, flush out
the pipework. Turn off the water supply before commencing installation.
2) Determine the fixing position and prepare recess for the faucet body. Make the recess in the wall according to
the dimension of the faucet body, the recess should be approximately 200mm x 49mm. The faucet body should
be fitted below the finished surface to allow the cover plate to fit correctly and flush against the wall. [ B ]
3) Position the faucet body in place and mark through the pre-drilled screw holes on the body, then drill the
marked points before inserting wall plugs into the wall holes. [ C ]
4) Connect the cold water inlet and hot water inlet correctly. If in any doubt please consult with a qualified trades
person.
5) Hold faucet body in place and secure to the wall with supplied fixings.
Figure D
Figure C
Figure B
Figure A
Faucet
body
Fixing Kit
Cover
plate
Spout
Lever
handle
hot inlet
cold
inlet
80mm
www.cavalierbathrooms.co.uk
C20 V2
Wall Mounted Basin
Mixer Instruction
IMPORTANT
Please read these instructions carefully and
keep in a safe place for future reference. If you
are unsure of any part of the instructions in
this document then we recommend that you
contact a reputable qualified trades person.
INTRODUCTION
The Model supplied may vary from the image
shown below. Please note that the general
installation process for all Wall Mounted taps
are the same and the following guide will take
you through the process.
