Remtron Pump Boss II
User Manual
19
9M02-8814-A001-EN
Version 2.3
7.
Using Your System
WARNING
Before operating the remote control system, make sure it is safe to do so. Adhere to the same
safety precautions normally required for safe pump operation. DO NOT leave the transmitter
unattended while the pump engine is operating.
WARNING
Do not operate the system until you are familiar with the operation and safety procedures for the
pump.
WARNING
To stop the system in an emergency, press and hold the red STOP/OFF button to stop all
functions.
Place the ignition switch ON to power the receiver. Verify that
the receiver ‘POWER’ LED illuminates. If it does not
illuminate, check the power connections to the receiver.
Note:
The transmitter antenna is located inside the top of the transmitter case. Achieve normal range with the
transmitter worn on your body. Moving the transmitter away from your body or holding it in the air can
achieve extended range and operation in difficult areas. Pointing the transmitter towards the receiver
provides the greatest signal.
7.1
Starting the System
Press the transmitter ‘ON’ switch and observe that the bicolor transmitter LED flashes GREEN. If the transmitter
LED flashes RED and then GREEN, the batteries are low and should be replaced at the first opportunity. Note
that when the RED
‘low battery’ condition is first observed, the operator has approximately eight hours of
operation left before the transmitter shuts down.
Once the transmitter is switched ON, if no switches are operated within one hour, it will automatically switch itself
OFF
. Note that operation of any switch except the red ‘STOP/OFF’ switch resets the one hour timer. Operating
the transmitter’s ‘STOP/OFF’ switch shuts down the system.
Further note that when any other transmitter switch is pushed in conjun
ction with the ‘ON’ switch, the transmitter
LED illuminates solid RED
. This condition prevents any pump operation. First pressing the transmitter’s red
‘STOP/OFF’ switch and then pressing the ‘ON’ switch will clear this condition.
7.2
Pump Operation
With the transmitter switched ON, pressing the top half of the ‘PUMP/OFF’ rocker switch starts the pump.
Pressing the bottom half of the ‘PUMP/OFF’ rocker switch turns the pump OFF.
Pressing the red ‘STOP/OFF’ switch also shuts off the pump and the transmitter. However, the ‘ON’ switch and
the top half of the ‘PUMP/OFF’ rocker switch must be pressed in sequence to reactivate the pump.
!
!
!
