Cattron MKU OCU, Руководство пользователя

Страница: 27 / 41

27
MKU OCU
User Manual
11.2 Activating Programming Mode
Refering again to Figure 12, set the OCU to 'Programming Mode', as follows:
•
With the OCU switched off, hold the ‘ENTER’ pushbutton fully down (second step) and switch on the OCU
using the rotary ON/OFF switch. The system will start
up with the ‘STATUS’ LED illuminating red.
•
Continue to hold the ‘ENTER’ pushbutton for approximately 5 seconds until the ‘STATUS’ LED changes from
permanent red to fast-flashing red and then release the
‘ENTER’ pushbutton.
•
Within 3 seconds after the
‘STATUS’ LED starts flashing red, press the ‘UP’ and ‘DOWN’ pushbuttons
simultaneously at the first and second level (Level 1 then Level 2).
•
The OCU is now in 'Programming Mode’. The ‘STATUS’ LED blinks orange and the current RF channel will
be indicated via a color code using the 4 function LEDs, as illustrated in Figure 13 and shown in the following
tables.
Note: The RF Channel Color Code Tables for the various bands are shown below.
Figure 13: Function and Status LEDs
Table 1: RF Channel Color Code Table for 433 MHz Band
LED Color
Channel Frequency 1 2 3 4
1 433,0775 - - - red
2 433,1025 - - - green
3 433,1275 - - - orange
4 433,1525 - - Red -
5 433,1775 - - Red red
6 433,2025 - - Red green
7 433,2275 - - Red orange
8 433,2525 - - Green -
9 433,2775 - - Green red
1
–
4: Function
LEDs
5:
‘STATUS’ LED