Cattron CANplus CP1000, Руководство по эксплуатации, Страница: 19 / 57

CANplus CP1000
Control Panel Operation Manual
*Patent Pending
19
9M02-1000-A401-EN Revision G
*
LED Select
·
Red, Amber
*
LED Flash Rate
· Slow, Fast, Solid
Communications
• CAN bus Settings
– TSC1 Address
– Panel Address
–
CM1 Address
– Interlock Address
– Config Address
– Termination
•
Modbus
–
Baud
– Parity
– Address
– VFD Model
– Tri Vibe Sensor
•
Telemetry
– Cell Status
–
GPS Status
– Geofence Setup
•
Bluetooth
– Pair New Device
– Status
–
Delete Bonds
3.8.2 Access Levels
The available menu items are dependent upon the current access level. The current access level is shown in the
upper right corner while in the menus. The CP1000 supports up to three independent PINs that are configurable.
The standard CANplus configuration has the following PINs settings:
•
User = 1000
•
Tech = 1111
•
Admin = 2222
• Menu PIN Required = OFF
Elevate Access Level
When the panel is turned on, the access level reverts to the User level. To gain access to the Tech or Admin
levels, use the Elevate Access Level menu, as follows:
Configuration → System → PIN Settings →
Elevate Access Level
.
The panel will prompt for a PIN input. User, Tech or Admin level access will be granted based on which PIN is
entered. For example, if the Tech level PIN is entered, Tech level access will be granted, and similarly if Admin
or User level PINs are entered. If the entered PIN does not match User, Tech or Admin, then “Incorrect PIN” is