G e n e r a l i n f o r m a t i o n
To activate or deactivate transmission barring, select
→
→
. Transmission
barring should be active before you enter the area where you want
transmission to be barred.
or
is displayed in the idle mode when
transmission barring is active. Depending on predefined radio settings, the
radio may send a notification message to the network about the activation.
is displayed if the message does not need to be sent or message sending
failed, and
is displayed if the message has been sent.
Q
Network selection
In addition to your predefined home network, you may be able to select other
networks in which your radio can operate (network service), for example, if
you are not in the coverage area of your home network. The network can be
changed automatically or manually; see Network selection on page 88.
Some services are network dependent, so the availability of services may
change when the network is changed. In addition, the selected folder,
selected group, home group, or the availability of groups may change when
the network is changed.
Q
Using your radio in wet and damp conditions
•
You can use this radio in the rain, but do not submerge it in water.
•
If the radio or the system connector has been exposed to salt water, wash it
immediately with freshwater to avoid corrosion. The radio must be carefully wiped
dry.
•
Before opening the back cover, dry the radio to prevent water from reaching the
interior of the radio. The battery is not water resistant.
•
Never charge the radio when the bottom connector is wet or damp.
•
Never use a damp radio with enhancements that have an electrical function (such as
a desk stand or car kit).
Note:
Make sure the interior of your radio and the back cover seals are dry,
clean, and free of any foreign objects. Foreign objects may damage the seals
against water.
Polaris_en_print.book Page 13 Tuesday, October 23, 2012 12:30 PM