EN
1. Adjust the temperature: Press the button
, the set temperature is displayed. Push the button
Where
to modify and store the displayed value. Push the button
to exit the setting and display the
cold room temperature.
2. If no other button is pressed within 10 seconds, cold room temperature will be displayed.
3. Lighting: Press the button
, it lights up; press again, it stops.
Manual defrost with stop/start:
Push the button
and hold for 6 seconds to defrost or stop defrost.
4. Refrigeration LED: During refrigeration, the light is on; When the cold room temperature is constant, the
light is off; During delayed start, the light flashes.
5. Defrost LED: during defrost the LED is on; when defrosting stops, the LED is off. During the delayed
defrost display, the LED flashes.
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
Manual :
- The device must be completely removed from its packaging. All guards must be completely removed.
- Place the appliance upright on a solid, flat surface Never put the refrigerated display case on a flammable
surface. Position this machine in such a way as to ensure optimum air circulation. We advise you to keep a
minimum distance of 10 cm from the wall and other objects.
- Do not install this device near open fires or other heating devices.
- Do not install the device in a wet or damp place.
- The electrical cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will trip the device.
