68
Switching the Data Projector Connection Profile
The Data Projector uses one of its six connection profiles to connect to a computer over
a wireless LAN. You can use the following procedure to switch the connection profile as
required.
To view the Data Projector’s current connection profile information
1
While Wireless is shown in the projection area, press the [FUNC] key on the
Data Projector’s remote controller.
z
This will display the Wireless function menu.
z
The contents of the Wireless function menu will differ according to the operational status
of the Data Projector when you press the [FUNC] key. The above example shows the
menu when the [FUNC] key is pressed while “Standing by for connection...” is displayed
in the projection area.
2
Check to make sure that “View Connection Info” is selected and then press the
[ENTER] key.
z
This will display the connection information window, which shows the currently selected
profile and the settings of the profile.
3
To close the connection information window, press the [ESC] key of the Data
Projector’s remote controller.
Note
You can also view the Data Projector’s current connection profile information using the
Web Setup top page. For more information, see “To display and log into the Web Setup
page” (page 65).
(Simple Connection Profile)
(Manual Connection Profile)
