Casio MX-X300, Руководство пользователя, Страница: 57 / 90

EN-56
MIDI Recorder (Tutorial)
6.
After you are finished punch-in recording,
touch “
Y
”.
Anything in the track following the point where you
touched “
Y ” will be retained as-is.
• If you want to cancel punch-in recording part way
through and retain the original track data, touch
“Cancel Punch”.
You can use the following procedure to specify a
particular range for punch-in recording.
1.
Enter the MIDI recorder recording mode and
then select the track where you want to
perform punch-in recording.
•
For information about how to select a track, see steps
4 and 5 under “Recording to a Specific Song
Performance Part (Track Recording)” (page EN-54).
2.
Use “
s
” and “
d
” to display the first
measure of the section you want to record
and then touch “Set A”.
3.
Use “
s
” and “
d
” to display the last
measure and then touch “Set B”.
4.
Touch “
Y

” to return to the beginning of the
song, or use “ s ” and “ d ” to adjust the
position to start playback.
5.
Touch “Rec Type”.
6.
Touch “Punch In A-B”.
7.
Touch “

”.
• Punch-in recording automatically starts when
playback reaches the start point and ends when it
reaches the end point you specified in step 3.
Use the procedure below to specify a punch-in
recording area that includes a part of a measure.
Example: To re-record from beat 3 of measure 2 up to beat
1 of measure 4
1.
Use the MIDI Recorder to start playback of
the song that contains the section you want to
re-record.
2.
When playback reaches the point where you
want to start punch-in recording, touch
“Set A”.
•
After touching “Measure”, “Beat”, or “Tick” for Point
A, you can then use the
9
w
,
q
buttons to make
fine adjustments to the start point.
Specifying the Punch-in
Recording Location
(Auto Punch-in Recording)
Start measure End measure
Punch-in recording range
To re-record an area smaller than one
measure
To re-record this section