E-15
Touch key panel
The touch panel appears on the Data Collector’s LCD. Be sure to use only your finger or the
stylus that comes with the Data Collector to operate the touch panel.
Using the touch panel stylus
The touch panel stylus is attached to the right
side of the Data Collector.
Important!
Use the procedure below to calibrate the touch panel whenever it
appears that it is misaligned on the LCD.
To calibrate the touch panel
1
Use a paper clip or some other thin, pointed
object to press the Initialize button on the
back of the Data Collector. This launches the
system initialization routine, which causes
the touch panel calibration screen shown
nearby to appear on the LCD.
2
Touch the center of each cross with the
stylus in the sequence indicated by the
arrow.
3
The touch panel calibration screen will be
cleared automatically after you touch all four
crosses.
CALIBRATION
Carefully press on
the center of the
each cross by PEN.
1.SYSTEM MENU
2.RETRY
3.EXIT