Alarm
The watch beeps when a specified alarm time
is reached. You can configure up to two
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
●
Snooze causes the alarm to sound up to
seven times, at five-minute intervals.
Note
●
The alarm and hourly time signal times
are synced with the watch’s digital
time.
Configuring Alarm Settings
1.
Enter the Alarm Mode.
l
2.
Use (D) to scroll through alarms ([AL1],
[AL2], [SNZ]) until the one you want to
configure is displayed.
Alarm time
Alarm number
3.
Hold down (A) for at least one second.
Release the button when the hour setting
starts to flash.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
4.
Use (B) and (D) to change the hour setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
5.
Press (C).
This causes the minutes digits to flash.
Alarm minute
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to complete the setting
operation.
●
Testing the Alarm
In the Alarm Mode, hold down (D) to sound the
alarm.
●
To stop the alarm
Pressing any button while the beeper is
sounding stops it.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
l
Turning Off an Alarm or the Hourly Time
Signal
Note
●
A beeper sounds for 10 seconds when
an alarm time is reached.
●
The watch will automatically return
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
●
[SIG] (hourly time signal) is shown on
the display while the hourly time signal
is enabled.
Watch Operation Guide 5699
9