Case CX300C, Руководство оператора

Страница: 105 / 288

3 - CONTROLS/INSTRUMENTS
Cab internal lighting
The light is located on the left-hand cab upright and is
controlled by a three position switch set in the lamp base.
Positions: “On” (continuous operation), “Off” (shut-
down) and intermediate position goes off 30 seconds
after closing the door.
ATTENTION: Make sure that the lights are switched off af-
ter use, otherwise the batteries may become discharged.
NOTE: To replace bulbs, (Refer to page 6-81 ).
9BWN45-001A
1
Emergency exit hammer
Located on the left-hand cab, use the hammer (1) to break
the rear window, and then push the window strongly and
escape outside.
Consult your CASE CONSTRUCTION dealer for window
installation.
ATTENTION: Do not break the rear window except when
it is absolutely necessary, such as to escape in an emer-
gency.
ATTENTION: Do not place anything in front of the window.
Doing so may obstruct an emergency escape.
KUXZSM-001
1
3-55