Case CX130C, Руководство оператора

Страница: 135 / 282

5 - TRANSPORT OPERATIONS
5 - TRANSPORT OPERATIONS ###_5_###
Road transport
Transporting precautions (Machine equipped with long arm)
The 3.01 m ( 118.50 in ) arm has two positions for fixing the arm cylinder pin:
SMIL20CEX0655EA
1
A. Working position; B. Transport position
The position (A) must be set for normal operation. The position (B) should be set for road transport.
To prepare a machine equipped with the 3.01 m ( 118.50 in ) for road transport proceed as follows:
1. Park the machine on a hard and level surface close to the transport trailer.
2. Fully open the bucket and extend the arm. The arm cylinder shall be not fully retracted.
3. Lower the boom so that the arm touches the ground, and so that the boom-arm cornering area can be reached
from the ground.
4. Set the gate lock lever in central position, stop the engine, and remove the starter key.
5. Place a block between the arm cylinder and the boom top plate to support the arm cylinder.
6. Remove the fixing bolt of the arm cylinder pin, and remove the pin from the working position (A) .
7. Get onto the cab, start the engine, and set the gate lock lever in forward position.
8. Slowly retract the arm cylinder eye out of the working position (A) on the arm bracket.
9. Slowly operate the boom and the arm cylinder to align the cylinder eye to the fixing hole of the transport position
(B) on the arm bracket.
10. Set the gate lock lever in central position, stop the engine, and remove the starter key.
11. Insert the arm cylinder pin in the transport position (B) . Tighten the fixing bolt of the arm cylinder pin.
12. Remove the supporting block between the arm cylinder and the boom top plate.
The machine is now ready for loading on the transport trailer.
NOTICE: Make sure to fully retract the arm and fully curl the bucket keeping away from the cab. When the arm cylinder
pin is set to position (B) , the arm gets closer to the machine and the bucket may hit the cab. Collision between the
bucket and the cab can cause serious damages.
After unloading the machine from a transport trailer, the arm cylinder pin must be set in the working position (A) .
Follow the procedure above reverting positions (A) and (B) .
NOTICE: Never use the machine in normal operation with the arm cylinder pin in the transport position (B) . This will
cause serious damages to the arm.
5-1