Case 621G Stage IV, Оригинальное руководство пользователя

Страница: 300 / 430

7 - MAINTENANCE
Selective Catalytic Reduction (SCR) in-line filter - Cleaning
Clean the in-line supply filter every 500 hours or more often if conditions so require. The supply line has a small mesh
filter within the line.
Prior operation:
Keep all non-authorized personnel clear of the area. Park the machine on level ground, in neutral with the parking
brake applied and the attachment lowered to the ground.
1. Lower the bucket/attachment to the ground and install
the transport/service link into the locked position.
LEIL16WHL0048AB
1
2. Open the engine compartment. The in-line supply filter
is located on the right-hand side of the machine directly
above the Supply Module.
LEIL14WHL0012AA
2
3. Use a suitable container to catch any fluid that is dis-
charged during hose and filter disassembly. Clean the
area before disassembly. Disconnect the supply line
by squeezing the tabs on the connection and separate
the lines.
4. Using needle nose pliers, remove the filter using care
not to damage or bend filter. If the fitting does not re-
lease easily, reclean the fitting with compressed air. Di-
rect the compressed air down into the fitting, then squirt
water into the fitting to lubricate the O-ring.
5. Inspect the filter housing and rinse with water. If the
filter is damaged, replace the filter.
6. Reinstall the filter into the supply line and reconnect the
lines.
7. Start the engine and run at idle speed. Check for leaks.
LEIL14WHL0014AB
3
7-92