C
HAPTER
4
16
Case IH Titan 4XXX - Steering Ready, Model Years 13 and Newer Raven SC1 HDU Guidance and Steering Installation Manual
FIGURE 11. Viper 4 Connections
5. Connect the round 16-pin connector on the ISOBUS cable (P/N 115-7300-148) to the machine’s mating
connector located on the machine’s A-post.
NOTE:
SC1 will not work without this cable.
INSTALLING THE ISOBUS EXTENSION HARNESS (IF APPLICABLE)
If a New Leader ISO Bed is on the machine, perform the following steps:
1. Remove the cover over the A-post.
2. Locate the 3-pin ISOBus terminator.
