2 – SET-UP SCREENS
AFS AccuControl Anhydrous Ammonia
AFS Pro 700 Quick Reference Card
(v28.* and after)
REQUIREMENTS
The following actions are required for proper operation. Working
through this document in order will properly set up your
anhydrous ammonia (NH
3
) system for application. This guide is to
be used as quick reference only. Insert a data card in the display
before turning the display on.
DANGER!
1.
Anhydrous Ammonia (NH
3
) Under Pressure. Anhydrous
ammonia can cause severe burning, blindness, or death.
Carefully read and follow all safety instructions and warnings
before operating or servicing equipment.
2.
Always wear proper personal protective equipment when
working with Anyhydrous and anhydrous ammonia.
1 – GENERAl NAvIGATIoN
1.1 Main Screens
Main screen
Status/Warnings
Navigation Bar
Left Hand Ar
ea
2.1 operator
Toolbox>oper
a) Create an operator
b) Select preferred
units of
measurement
2.2 GPS Setup
Toolbox>GPS
a) Verify GPS Location
b) Verify Offsets
c) Verify DGPS Type
3 – ANhyDRoUS CoNfIGURATIoN
3 – ANhyDRoUS CoNfIGURATIoN – continued
Toolbox>AccuCtrl
Note:
Activation is required (
Toolbox>Activate
)
prior to these steps.
3.1 Basic Setup
a) Select AccuCtrl Operation
[Anhydrous]
b) Select AccuCtrl Installed
[Yes]
c) Create New Implement
d) Select Implement Type
[Anhydrous Toolbar]
3.2 Implement Configuration
a) Press ‘Setup’
b) Select Drive Type
c) Select Vehicle Type
d) Set Number of
Drive Sections [A]
NoTE!
Section Control
information entered in 3.3.
e) Set Total Number
of Rows [B]
f) Enter Row Width [C]
g) Enter Bar Distance in Inches
(axle to knife) [D]
NoTE!
Verify GPS Offset (
Toolbox>GPS
)
h) Measure Implement Right/Left Offset [E]
i) Enter Rows Per Drive Section
j) Press ‘Done’
NoTE: The next setup steps may or may not be needed.
The configuration of the Nh
3
toolbar determines the need
for setup. If the toolbar is not equipped with the capability,
leave the setup as ‘No’.
3.3 Section Control Setup
(If equipped with Section Shutoff valves)
a) Select Row Clutch [Yes]
b) Press ‘Setup’
c) Assign Module
Serial Numbers
(starting w/modules
on LH side)
d) Assign Rows Per Output
(Number of Rows
per Group)
e) Select Control Polarity
Note:
Active On is common
for Section Control Valves.
f) Select ‘Done’
