CASE CONSTRUCTION CX75C SR, Руководство оператора

Страница: 82 / 256

3 - CONTROLS/INSTRUMENTS
RIGHT-HAND SIDE CONTROLS
Right-hand side controls
SMIL13CEX2868EB
1
1. Starter switch
This switch has four positions, ON (contact), START
(engine ignition), OFF (engine shut-down) and ACC
(accessory current supply).
NOTICE: when the ignition key is in ON (contact) posi-
tion, if the anti-theft protection has been programmed,
then it will be necessary to enter the code. The mes-
sage "Password" will be displayed. Refer to page
4-1 .
NOTE: this key is also used to lock the cab door, the
engine hood, the front storage compartment, the side
doors and the fuel tank cap.
2. Engine acceleration button and working mode selec-
tor
This button enables an increase or reduction in the
engine speed. This button is coupled with the three
working mode selector:
Mode
A (automatic) when the energy output has pri-
ority.
In this mode, the balance between the speed and en-
ergy output is controlled for each movement of the
controls.
Mode
H for difficult excavation work or if the load in-
creases, and mode SP when the output has priority.
Each selected mode ( A , H or SP ) is displayed on the
screen.
NOTE: to select the SP mode, operate the indexing
pin while rotating the acceleration button to the right.
NOTE: if there is no change in engine speed, press
and release the engine automatic idle speed selector.
3. Engine idle speed selector
This control enables automatic engine idle without op-
erating the throttle button. To select idle speed, press
and release the control for the engine automatically
to go into idle speed; the "Engine idling" icon will ap-
pear on the message screens. When the control is
pressed and released once more the engine will re-
vert to its original speed and the icon on the systems
display panel will disappear.
4. Option switch
5. Wiper switch
When this switch is pressed, the wiper moves.
6. Travel caution alarm switch
With the switch in the CONT position, an alarm sounds
when the travel control is operated. With the switch
in the
AUTO OFF position, an alarm sounds for 10 s
when the travel control is operated.
7. Cab radio compartment
This pre equipped compartment is provided for in-
stalling a
24 V vehicle radio. For details on the ve-
hicle radio operation, read the operator’s manual that
comes with the car radio.
8. AUX (external input)
During radio reception, you can connect a commer-
cially-available audio portable unit and listen to music,
etc.
3-34