M6028 • 01/19/17 • © 2017 Casablanca Fan Company
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with RSS-210 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: Reorient
or relocate the receiving antenna, Increase the separation between the
equipment and receiver, Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer
or an experienced radio/TV technician for help. Note: Any changes or
modifications to the transmitter or receiver not expressly approved by
Hunter Fan Company may void one’s authority to operate this remote
control.
This product conforms to UL Standard 1917.
Rated for ceiling fan max load of 1 amp.
Rated for light wattage of max 300 watts.
WARNINGS
CEILING FAN REMOTE ADD-ON RECEIVER
Model 99199
The Casablanca Add-On Receiver works with
Casablanca pull chain fans and requires a compatible
transmitter (sold separately).
CASABLANCA FAN COMPANY CONTROL LIMITED WARRANTY
This product is warranted to the original purchaser by Casablanca
Fan Company against defects in material and workmanship for
one (1) year from date of purchase. During the warranty period,
we will repair or, at our option, replace a defective product at
no charge. For information on how to obtain service, contact
Casablanca’s Service Department by calling our toll-free number
at 1-888-227-2178. Damage to the product caused by mishandling,
improper installation or modification is not covered by this
warranty. This warranty is given in lieu of all other warranties
expressed or implied. Some states do not allow limitations of time
on an implied warranty, therefore the above limitations may not
apply in every case. This warranty states specific legal rights which
may vary from state to state.
2
4
Install the receiver
INSTALLATION
1
Use the pull chains to set the fan speed to
HIGH
and the light to
ON
.
Prepare fan
Ensure the power is OFF at the outlet box and
wall switch location before proceeding with
installation.
Turn
Pow
er
OFF
Turn off the power
READ AND SAVE THESE INSTRUCTIONS
If you are installing multiple remote-controlled fans
on the same circuit breaker
,
you may need to perform a few extra steps to prevent interference or faulty
operation of your remote controls.
Go to www.CasablancaFanCo.com/FAQs and click “How do I properly install multiple
remote-controlled fans?” for more information.
Choose the hanging system to the right
that most closely resembles the one
used by your fan and place the receiver
as shown.
WARNING:
This receiver cannot be
installed in conjunction with any other
receiver or hard-wired wall control.
Doing so will void your warranty.
Note:
If your canopy is crowded with
excess wire, you may wish to cut the
excess fan wires. Leave a minimum of
8 inches remaining. Strip the fan lead
wires 1/2 inch. Place remaining excess
wire into the ceiling electrical box.
The
bracket and fan must remain properly
grounded.
3
Remove the canopy
If uncertain how to remove it,
reference the fan’s owner’s manual.
With wiring exposed, you may wish
to note existing wire connections or
take a photo for reference.
Remove
the wire connectors that connect
the wires from the outlet box to
the fan, leaving the grounding wires
connected.
Receiver
Canopy
Hanging System 1
Receiver
Canopy
Hanging System 2
Ceiling
Plate
Receiver
Canopy
Hanging System 3
Ceiling
Bracket
Receiver
Fan Body
Cable Tie
For low profile fans, the receiver should
be secured to the ceiling bracket with a
cable tie.
Hanging System 4
To avoid possible electrical shock, before installing or servicing your fan, disconnect the power by
turning off the circuit breakers to the outlet box and associated wall switch location. If you cannot
lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel.
