Part Number 9991700 12/14/04
36 Motor Yacht Setup
Page 1 of 3
1. Install props.
2. Remove tape and clean the areas where
the bridge will set. Check for voids along
the top of the windows.
3. Apply sealant (732 white multi-purpose
sealant) around deck bolts.
4. Lifting points for the bridge are between
the two stand-offs on the forward bridge
rail and two lifting eyes on the forward
part of the aft deck hardtop. Position
bridge over boat. Run the appropriate
wires to the aft port corner; and run the
drain line, water line, and appropriate
wires to the aft starboard corner.
5. Set bridge in place, making sure that no
wires or hoses get caught or pinched off.
Make sure the bridge is pushed all the
way forward.
6. With the bridge in place, bolt it down:
a. Five bolts under helm.
b. One bolt on each side aft.
7. Install exterior seating on bridge.
8. Install mast light and TV antenna on
arch.
9. Connect all dash wiring and wet bar
hoses in the aft starboard corner.
10. Cosmetically seal around the back edges
of the bridge.
11. Install bow rails.
36 Motor Yacht Setup
