15
//
Gb
aSSembLIng tHe boat StanD
aSSembLIng tHe rc unIt
Assemble the 4 parts of the boat stand as shown in the diagram.
Ensure that the lettering faces outwards. Then glue the parts
together using superglue at the points marked with an arrow. Fix
the parts in position on a table or similar flat surface so that the
boat stand rests on it evenly.
caRSon ReFleX SticK 6
An appropriate RC unit must be in service before you can take
your new model boat onto the water. We recommend our 2.4
GHz transmitter tray unit CARSON REFLEX STICK 6 Channel Article
no.: 500501006 which has been used here as an example in the
following steps. You can achieve a maximum range of approx. 100
metres with the REFLEX STICK 6 Channel.
Place your model boat on the pre-assembled boat stand (adhesive completely cured) and stay well clear of the propellers at all times.
Carefully remove the model’s cover and have your receiver, RC unit and a fully charged driving battery ready. Now insert the receiver plug
of the speed controller into the throttle channel connection on the receiver. For the REFLEX STICK, the plug must be inserted into channel 2.
Insert the plug of the steering servo into the connection for channel 1 (for REFLEX STICK) on the receiver. For further information, refer to
the Operating Instructions supplied with your remote control.
pay attention also to the notes and information included in the instructions supplied for the speed controller.
connect the speed controller, motor, receiver and battery as shown in the diagram below:
Art. Nr.: 500501006
approx.
100 m range
electric motor
2x
speed controller
receiver
to the battery
on/off switch
black
red
to the receiver
(Channel 1)
steering servo
(Channel 2)
