Carson Airbeast II Pro, Инструкция по эксплуатации

Страница: 41 / 108

41 CARSON Helicopter Airbeast II Pro
GB
k. Troubleshooting
Please read this before something happens.
Should be problem Cause Reparation
The model does not move 1. Check whether the transmitter and the model
are switched on
Switch on transmitter and/or model
2. Check the battery voltage of transmitter and model
battery Employ completely charged batteries
3. The trim slider of the pitch-function stands on the
upper
stop
Ensure that the trim slider of the pitch function is
in neutral position or somewhat below
Motor does not turn 1. Motor is defective Exchange the motor
2. Motor is too hot Allow the motor to cool down
The model reacts
incorrectly to the control
commands or flies choppily Check the state of the transmitter and model
battery charge Employ completely charged batteries
The model does not
take off 1. Rotor blades are twisted Exchange the rotor blades
2. Motor is too hot Allow the motor to cool down
3. Batteries are empty Charge the batteries or exchange them
The rotors do not allow shut
down Trim is not correctly adjusted Correct the trim on the pitch controller
The model moves forwards/
backward and sidewise, but
does not hover Check whether the helicopter is exposed to a draught, e.g.
by an opened window or an air conditioner. Hover flight is
not possible when there is a draught Close the window/door, switch off the air condi-
tioner or select a more suitable room
The model vibrates severely 1. Check whether the principal rotors run true Possibly change the rotor blades
2. Check whether the model is correctly balanced Possibly change the rotor blades
The tail does not permit
stabilizing 1. One or more rotor blades are defective Replace one or both rotor blades
2. Lower and upper rotor revolution run with different
friction on the rotor shaft
Ensure that both rotor revolutions allow for easy
rotation
3. The velocity of rotation of the upper and lower rotor
revolution is uneven
Correct the trim on the transmitter