Carrier TruVu VVTZC-E2, Руководство по установке и запуску

Страница: 90 / 146

To set up the controller through the Comm/Service ports
TruVu™ VVTZC -E2 ©2022 Carrier.
Installation and Start-up Guide All rights reserved.
84
BACnet tab
NOTE The TV-VVTZC-E2 can be configured for only one BACnet communication type.
On the BACnet tab, you can choose to run BACnet Over IP or BACnet Over Ethernet on the Eth0 and Eth1 ports.
If you choose BACnet Over IP , you can edit the BACnet UDP Port .
Security tab
BACnet Firewall If your BACnet Firewall configuration in the i-Vu® interface did not include the i-
Vu® server IP address, thus blocking communication with the i-Vu® server, you
can disable the controller's BACnet Firewall on the controller setup
Security tab.
NOTE You can enable the BACnet Firewall only in the i-Vu® interface.
Local Network tab
Use the Local Network tab to:
•
Discover 256 i-Vu® XT or TruVu™ devices on a single network at a time.
•
Discover both configured or unconfigured devices on this controller's network.
•
See the number of devices discovered and the total number on the network.
•
Identify the i- Vu® XT or TruVu™ controller that has had its DSC button pressed.
•
Export the Local Devices that are present in the table (limited to 256) to a .csv file.
•
Set a device's Mode , Address , and Location .
•
Assign IP addresses to multiple devices at one time.
•
Prompt an LED to blink on a device.
A device that is new from the factory or has not been previously configured with an IP address, can always be
configured using the
Local Devices table. However, once you have assigned a valid IP address, you have up to 24
hours to make any other changes. After 24 hours, the fields are not editable and the device is Locked .
You can unlock a device for 24 hours by either pressing the DSC button on the TV-VVTZC-E2 controller or by using
the i-Vu® application. In the i-Vu® navigation tree, right-click the TV-VVTZC-E2, select
Driver Properties and go to
Driver > Settings tab > Local Network Configuration . Check Allow Local Network Configuration from other
devices on the local network for 24 hours and click Accept .