Carrier TruVu UCXP683T-V, Руководство по установке и запуску

Страница: 55 / 76

To set up the controller through the Service port
TruVu™ UCXP683T -V CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
51
Local Network tab
Use the Local Network tab to:
•
Discover 256 i- Vu® XT or TruVu™ devices on a single network at a time.
•
Discover both configured or unconfigured devices on this controller's network.
•
See the number of devices discovered and the total number on the network.
•
Identify the i- Vu® XT or TruVu™ controller that has had its DS C button pressed.
•
Export the Local Devices that are present in the table (limited to 256) to a .csv file.
•
Set a device's Mode , Address , and Location .
•
Assign IP addresses to multiple devices at one time.
•
Prompt an LED to blink on a device.
A device that is new from the factory or has not been previously configured with an IP address, can always be
configured using the
Local Devices table. However, once you have assigned a valid IP address, you have up to 24
hours to make any other changes. After 24 hours, the fields are not editable and the device is Locked .
You can unlock a device for 24 hours by either pressing the DSC button on the TV-UCXP683T-V controller or by
using the i-Vu® application. In the i-Vu® navigation tree, right-click the TV-UCXP683T-V, select Driver Properties
and go to Driver > Settings tab > Local Network Configuration . Check Allow Local Network Configuration from
other devices on the local network for 24 hours and click Accept .
To discover devices on a network
1
To address a network of devices, you must first select one i-Vu® XT or TruVu™ controller and set the IP
Address , Subnet Mask , and Default Gateway on the Ports tab.
NOTE This controller is referred to as the connected controller.
2
On the Local Network tab, at the top of the page, verify that the connected controller's Mode , IP Address ,
Subnet Mask , and Default Gateway are accurate.
3
Use the following settings to define the devices that you want to discover in the Local Devices table.
Local Devices
Only Unconfigured When checked, only discovers devices that do not have an IP address and are
linked to the connected controller's network.
When unchecked, discovers both configured and unconfigured devices.
Clear All Erases all information in the table.
Export Creates .csv file of the data in the table, limited to 256 devices.
4
Click Discover to populate the table with your i- Vu® XT or TruVu™ devices that are on a single network
communicating with the connected i- Vu® XT or TruVu™ controller.