Carrier TruVu UCXP683T-V, Руководство по установке и запуску

Страница: 33 / 76

To adjust input and output properties
TruVu™ UCXP683T -V CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
29
Input values
Input I/O Type Sensor/Actuator Type Min/Max
Analog (BAI)
0-5 Vdc 0 – 5 Volt Linear Full Range Engineering values associated with 0
Vdc (Min) and 5 Vdc (Max)
1
No Translation N/A. The input microblock's value will be
the raw voltage of the input.
0-10 Vdc 0 – 10 Volt Linear Full Range Engineering values associated with 0
Vdc (Min) and 10 Vdc (Max)
1
No Translation N/A. The input microblock's value will be
the raw voltage of the input.
2-10 Vdc 0 – 10 Volt Linear w/Offset,
2 – 10 Volts
Engineering values associated with 2
Vdc (Min) and 10 Vdc (Max)
1
Thermistor Thermistor Select your Thermistor type or
set up and select a
Non-Linear,
Custom Table 2
N/A
Pulse to Analog (BPTA) 3
Pulse Counter Counter Input N/A N/A
Binary (BBI)
Dry Contact Dry Contact N/A N/A
1 The sensor reads a value and sends a corresponding signal (Volts) to the TV-UCXP683T-V's physical input. The
Analog Input microblock uses the Min and Max values to linearly translate the signal into the engineering value
used in subsequent control logic.
2 You can set up a custom translation table on the driver's Custom Translation Tables pages in the i-Vu®
interface.
3 The control program must have one Pulse to Analog Input microblock for each pulse counting input.