Carrier TruVu UC683T, Руководство по установке и запуску

Страница: 63 / 74

Troubleshooting
TruVu™ UC683T CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
59
To configure custom Prog LED
You can customize the Prog LED for site-specific purposes by configuring the BACnet Analog Output (BAO)
microblock.
Open your control program in the Snap interface, select the AO microblock for the LED, and use the following
settings:
Status/Attribute Microblock
type
Expander number :
Channel number
I/O type Description
LED BAO 0:61 Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of
times given in the BAO with ON
pulse 0.5 seconds and OFF pulse
0.5 seconds.
To get a Module Status report
A Module Status report provides information about the controller and verifies proper network communication with
the controller. You can get this report:
•
In the i-Vu® application — Right-click the controller on the navigation tree, then select Module Status .
•
In the Field Assistant application — Right-click the controller in the navigation tree and select Module Status .
•
On the controller setup ModStat tab — See To set up the controller through the Service Port (page 46).
See Module Status field descriptions (page 66) in the Appendix.