Carrier TruVu MPC, Руководство по установке и запуску

Страница: 18 / 67

To attach I/O expanders
TruVu™ MPC Processor CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
14
To wire the TruVu
TM
MPC I/O expander to the I/O Bus port
Use ARC156 wiring (22 AWG, low-capacitance, twisted, stranded, shielded copper wire) to wire the TruVu
TM
MPC
I/O expander to the controller. Do not exceed 1000 feet (305m) total wire length for the I/O bus.
WARNING Do not apply line voltage (mains voltage) to the expander's ports and terminals.
1
Turn off the controller's and expander's power.
2
Wire the expander's I/O Bus port to the same port on the controller.
NOTES
○
To use more than one expander, wire their I/O Bus ports together in a daisy-chain configuration. The
controller must be the first device on the expander network.
○
Use the same polarity throughout the network segment.
3
On the last expander on the I/O bus, set the I/O Bus End of Net? switch to Yes to apply network termination
and bias.
NOTE The controller has built-in I/O bus network termination and must be the first device on the expander
network.
4
Mount the TruVu TM MPC I/O expander to a DIN rail or using screws as described in steps 3 and 5 above.
5
Turn on the controller's and expander's power.
To attach MPC Open XPIO expanders
Use ARC156 wiring (22 AWG, low-capacitance, twisted, stranded, shielded copper wire) to wire the MPC Open
XPIO expander to the controller. Do not exceed 100 feet total wire length. See the Open Controller Network Wiring
Guide for complete wiring specifications.
Wire the TV-MPCXP's Xnet port to the MPC Open XPIO expander's Xnet Remote Expansion port. To use more than
one expander, wire their Xnet Remote Expansion ports together in a daisy-chain configuration.
The TV-MPCXP has built-in Xnet termination and must be the first device on the expander network. Add
termination to the last MPC Open XPIO expander by placing the
Term jumper (if provided) in the up position. If the
MPC Open XPIO expander does not have a Term jumper, you must add external network termination.
NOTE You must set the Xnet baud rate to 500 kbps in the i-Vu® interface on the driver's I/O Bus and Xnet
Expanders page. See Adjusting TV-MPCXP driver properties (page 33).