Carrier SmartVu control, Руководство по управлению

Страница: 48 / 52

8 - DIAGNOSTICS
50
8.6 - Alarm codes
Alarm No.
ALARMRST
Code
Description of the alarm text Reset type Probable cause Action taken by the
control
Sensor Failures
1 Th-204 Indoor air Thermistor #1
Automatic if the
temperature
measured by the sensor
returns
to normal
Defective thermistor Unit is shut down
2 Th-205 Indoor air Thermistor #2 As above As above As above
3 Th-202 Supply air Thermistor As above As above As above
4 Th-206 Space Temperature Offset As above As above
Space temperature
offset
function is ignored
5 Th-203 Return Air Thermistor As above As above Unit is shut down
6 Th-02
Water exchanger Leaving Fluid
Thermistor
As above As above Hot-water coil disabled
7 Th-03 Circuit A Defrost Thermistor As above As above Unit is shut down if
heating mode
8 Th-04 Circuit B Defrost Thermistor As above As above As above
9 Th-10 OAT Thermistor As above As above Unit is shut down
10 Th-12 Circuit A EXV Suction Thermistor As above As above As above
11 Th-13 Circuit B EXV Suction Thermistor As above As above As above
12 Th-14 Circuit THR EXV Suction Thermistor As above As above As above
13 Th-11 Mixed Air Thermistor As above As above unit is shut down
14 Pr-01 Circuit A Discharge Transducer
Automatic when the
voltage transmitted
by the sensor
returns to normal Defective transducer
or installation fault
Circuit is shut down
15 Pr-02 Circuit B Discharge Transducer As above As above As above
16 Pr-03 Circuit THR Discharge Transducer As above As above As above
17 Pr-04 Circuit A Suction Transducer As above As above As above
18 Pr-05 Circuit B Suction Transducer As above As above As above
19 Pr-06 Circuit THR Suction Transducer As above As above As above
20 Se-201 Indoor Air Quality sensor As above defective sensor
Indoor air quality
function is
disabled
21 Se-203 Relative Humidity sensor As above As above
Humidity control function
is disabled
Communication
Failures
22 Co-S1
Loss of communication with
SIOB Board Number 1
Automatic if
communication is
re-established
Installation bus fault
or defective
board
Circuit A is disabled
23 Co-S2
Loss of communication with
SIOB Board Number 2
As above As above Circuit B is disabled
24 Co-S3
Loss of communication with
SIOB Board Number 3
As above As above Circuit C is disabled
25 Co-A1
Loss of communication with AUX1
Board Number 1
As above As above Compressor VSPD is
disabled
Process
Failures and
Others
26 P-01
Water Exchanger Freeze
Protection
Manual
Heat exchanger water
below
2.5 °C
Indoor fan is off, 3 way
valve bypass line is
closed to enable hot
water pass inside the
coil
( hot-water system
feed).
27 P-05
Circuit A Low Suction
Temperature
Automatic when the
temperature
returns to normal,
and if this
alarmhas not
appeared during Pressure sensor
defective, EXV
blocked or low
refrigerant charge
Circuit is shut down