Carrier RTU-MP, Руководство по интеграции

Страница: 53 / 58

RTU-MP Controller 49
Date: 06/30/2008
Vendor Name:
Carrier
Product Names: RTU-MP
Product Model Number: RTU-MP
Product Description:
The RTU-MP is a factory-installed rooftop controller that is capable of speaking multiple protocols. When the
LonWorks Option Card (LON-OC), is installed in the field, it enables the RTU-MP to communicate over a
LonTalk network. The RTU-MP does not conform to a standard LonWorks profile, but is self-documenting and
any network management tool can manage and configure it over the network. An external interface file (.XIF),
is also available so that any network management tool can design and configure the RTU-MP prior to
installation. Contact your Carrier representative for this .XIF file.
LonWorks is an open protocol that requires the use Echelon's Neuron microprocessor to encode and decode
the LonWorks packets. In order to reduce the cost of adding the Echelon chip to every module, a separate
LonWorks Option Card (LON-OC) was designed to connect to the RTU-MP.
This accessory card must be ordered separately and is connected by attaching its ribbon cable into the
J15
connector on the RTU-MP. The RTU-MP’s baud rate ( DS1 and DS2 on SW3 ) must be set to 38.4k to
communicate with the LON-OC. The address switches ( SW1 and SW2 ) are not used with LonWorks.
Tranceiver Type : TP/FT 10
Appendix E: LonWorks Protocol Implementation Conformance Statement