8
© 2021 Carrier
MOUNTING NXTSD507HD
Method
The NXTSD507HD requires a non-symmetrical cutout and is secured using eight knurled-head thumb nuts.
Refer to the figure below for the layout of these thumb nuts.
Rear of NXTSD507HD showing placement of the knurled-head thumb nuts
The thumb nuts attach to threaded posts which are threaded into
inserts around the bezel of the screen. See the figure to the right
for a diagram of the thumb nut attached to the post. The post and
thumb nuts use M4x0.7 thread and the posts are 25mm long. If a
post and thumb nut are lost and need replacement, an M4x0.7
screw that is 10mm long can be used in combination with a
washer.
Post with knurled-head thumb nut
